I have seen a few posts on lomcn requesting help with routers, This is a basic guide to what i did:
1. Goto your router setup page and forward ports 3000 (Server Count)
7000 (LoginGate) 7100 (SelChrGate + LogSrv) 7200 (RunGate + DBServer)
2. Goto "Control Panel" --> "Add Hardware" --> Click Next --> Select "Yes, I have already connected the hardware" --> Scroll down and select "Add a new hardware device" --> Click Next --> Select "Install the hardware that i manually select from a list (Advanced)" --> Scroll to "Network adapters" --> Click Next --> Select "Microsoft Loopback Adapter" --> Click Next
3. Now that "Microsoft Loopback Adapter" is installed goto "Contol Panel" --> "Network Connections" and find the Loopback adapter, When you have found it right click and goto properties, Now on the "General" tab find "Internet Protocol (TCP/IP)" and select it --> Click Next --> select "Use the following IP address" and setup as follows.
IP address: [Internet IP Address]
Subnet mask: {Will Auto Fill}
Default gateway: [Leave Blank]
4. In your server files set all the IP's to your internet IP address
Hope this little guide helps someone as i had alot of problems gettin my server online.
Cheers
Chris
Also If you need some help finding out how to forward the ports on your perticular router goto:
www.portforward.com
Really good site, has most routers on their.
/Leglhta
1. Goto your router setup page and forward ports 3000 (Server Count)
7000 (LoginGate) 7100 (SelChrGate + LogSrv) 7200 (RunGate + DBServer)
2. Goto "Control Panel" --> "Add Hardware" --> Click Next --> Select "Yes, I have already connected the hardware" --> Scroll down and select "Add a new hardware device" --> Click Next --> Select "Install the hardware that i manually select from a list (Advanced)" --> Scroll to "Network adapters" --> Click Next --> Select "Microsoft Loopback Adapter" --> Click Next
3. Now that "Microsoft Loopback Adapter" is installed goto "Contol Panel" --> "Network Connections" and find the Loopback adapter, When you have found it right click and goto properties, Now on the "General" tab find "Internet Protocol (TCP/IP)" and select it --> Click Next --> select "Use the following IP address" and setup as follows.
IP address: [Internet IP Address]
Subnet mask: {Will Auto Fill}
Default gateway: [Leave Blank]
4. In your server files set all the IP's to your internet IP address
Hope this little guide helps someone as i had alot of problems gettin my server online.
Cheers
Chris
Also If you need some help finding out how to forward the ports on your perticular router goto:
www.portforward.com
Really good site, has most routers on their.
/Leglhta
Last edited by a moderator:
